-۲۰°C
ISOGUM-P
۲۰/۴/۱۳۹۵
T:09199761006
ISOGUM-P is a elstomeric modified bitumen waterproo
fing membrane (SBS), industriallymanufactured by impregnation of the reinforcement w
ith the waterproofing compound based on
distilled bitumen modified with elastomeric polymer
s of the latest generation, which gives to the
compound superior technical characteristics.
The composite reinforcement, made of nonwoven spunb
ond polyester in combination with fiberglass,
conveys good mechanical characteristics, excellent
dimensional stability and elastic performance.
Shaping of sheets, straightness, dimensional and su
rface uniformity are accomplished by hot
calendering of the mass at hot melt fluid state.
The upper surface is coated with anti-adhesive amor
phous sand. The lower surface is coated with a
thermo-fusibile polyolefin film.
DESCRIPTION
ISOGUM-P is particularly suitable as under layer an
d as intermediate layer in multi-layer waterproofin
g
systems, with compatible membranes; it is very appr
opriate where the substrate undergoes significant
and frequent movements.
General roofing, vehicles parking roofs, foundation
s, on or under floors or ground slabs, wall
constructions, are valid examples of the design app
lication of this product. It is not suitable for ro
of
gardens. It can be applied onto every substrate (co
ncrete, masonry, corrugated steel decks, tension
structures, pre-cast concrete roofs, wood, insulati
on panel, membrane, etc.) and under heavy
protection.
The excellent mechanical characteristics and high l
evel thermo-dynamic stability make it suitable for
any climate conditions, particulary cold climates,
and all the situations where a barrier against wate
r is
required.
FIELD OF
APPLICATION
METHOD OF
INSTALLATION
The excellent thermoplastic properties of the water
proofing compound allow the application with torch-
on system or hot air generator. In particular situa
tions, it could be applied with appropriate sealant
s.
The application of the membrane must be carried in
good weather conditions and after the substrate
has been adequately cleaned and prepared.
PACKING AND
STORAGE
The product is packed as standing rolls on wooden p
allets wrapped with thermoshrinking protective
hoods. Rolls must be stored in the upright position
, without stacking the pallets to avoid deformation
s
which can compromise the correct application of the
membrane. The product must be stored indoor,
protected from heat and frost.
DISPOSAL
The product does not contain dangerous substances a
nd can be considered as household rubbish or
industrial waste (identification code EWC170302).
INTENDED USE
OR USES
Flexible sheets for waterproofing. Reinforced bitum
en sheets for roof
waterproofing
EN13707:2013
Flexible sheets for waterproofing. Bitumen damp pro
of sheets
including bitumen basement tanking sheets
EN13969:2004 /A1:2006
۱٫
Anti-adhesive